China Mining&Construction Equipment Co., Ltd

Position: Home » Product List » Jack » KD3-5 Hand-cranking Span Top jack
  • KD3-5 Hand-cranking Span Top jack
  • KD3-5 Hand-cranking Span Top jack
  • KD3-5 Hand-cranking Span Top jack

KD3-5 Hand-cranking Span Top jack

KD3-5 Hand-cranking Span Top jack is the way of manual lifting tool, it can in a variety of projects and equipped with lifting falling-rising as roof is hand force through the gears, drive the lifting

Product Recommendation

  • Product Introduction
  • Product Parameter
  • Product Picture
  • Product Comment

Introduction of KD3-5 Hand-cranking Span Top jack

KD3-5 Hand-cranking Span Top jack is the way of manual lifting tool, it can in a variety of projects and equipped with lifting falling-rising as roof is hand force through the gears, drive the lifting or falling. When unloading heavy or down, left to move the ratchet will crank reverse rotation, manual control its speed, so as to better apply to the factory, warehouse, dock, railway, construction stack, etc, especially suitable for mobile installation of various machinery and equipment, locomotive maintenance, weight lifting, etc., the KD3-5 Hand-cranking Span Top jack design is reasonable, easy operation, flexible and reliable, to improve the work efficiency, reduce labor intensity play a good role. KD3-5 Hand-cranking Span Top jack Operation Method 1.According to the weight of gravity collapse given the placement of choice, KD3-5 Hand-cranking Span Top jack will not tip over when lifting; 2,Lifting and landing must be destroyed board or full collapse of the foot area in contact with the weight in order to ensure sufficient strength to prevent falling weight; 3.Place destroyed the top floor should be solid, such as the ground is soft, should be added under the base pads, destroyed the top of the center position on the pad; 4.Shake before use empty once, from low to high, check for stuck or anomalies, everything is normal to use. KD3-5 Hand-cranking Span Top jack Announcements 1.Before use must know the weight, the use of the track jack, it is strictly prohibited to overload, lest cause the equipment damage accidents; 2. If the weight more than rated lifting weight, need more than one top carrying operation at the same time, keep more uniform top load carrying, up and down speed is consistent, stable; 3. When the heavy lifting, if not unloaded in a short time, you must fill plus with heavy weights below ground clearance equal to the auxiliary pad as support.

Parameter of KD3-5 Hand-cranking Span Top jack

Model

Top rated

maximum

weight(T)

lifting height

(mm)

Foot carrying the

lowest position

(mm)

Take the top

extreme higher

position (mm)

The roof

bottom

(mm)

At the top

(mm)

weight (kg)

KD3-5

5

200

60

260

520

720

18.5

KD7-10

10

250

70

320

630

880

30

Pictures of KD3-5 Hand-cranking Span Top jack

Your Name Your Name

E-Mail Address E-Mail Address

Enquiry Enquiry